Flexible Metal Liners Page

fml2 We can advise on the selection of the correct liner for your particular requirements.

There are two distinct types of flexible metal liners available and we are experienced in the installation of both types – it is very important to distinguish between the types:

SOLID FUEL LINER. This is a doubleskinned liner made from an extremely high quality stainless steel, usually 904L or 316Ti (Titanium) grade. It is smooth on the inside, corrugated on the outside and must be installed the correct way up. It is specifically designed for relining flues for solid fuel and wood.  While there is presently no British Standard for solid fuel flexible liners, Building Regulations can be satisfied by referring to the HETAS Approved List or an approval by the CSTB (France), members of the European Union of Agrément.

GAS AND OIL FLUE LINERS .This is a lightgauge single skin liner, only suitable for closed gas fires and boilers, some inset fuel effect gas fires and kerosene oil appliances. It should never be used with solid fuel or wood burning appliances.

INSTALLATION.Flexible liners are relatively easy and clean to install. They are usually drawn down the chimney by rope from the top and will pass round mostbends without opening up the flue. Support is provided by “hanging” the liner from a clamp or plate mounted at the top of the chimney. It should also be firmly clamped at the base before forming the connection to the appliance or flue pipe. Unlike rigid pipe, expansion and contraction will be taken up by the flexible construction of the pipe itself. The solid fuel liner can be left with an air space as insulation. This may be satisfactory for open fires with relatively high flue gas speeds and temperature which will reduce the likelihood of condensation.  A better solution is to back fill around the liner with a loose fireproof insulation material such as Perlite, Vermiculite or Leca granules. Some systems offer an insulation wrap, well suited to the large voids found in inglenook situations where back filling would be impractical. (Fibreglass insulationshould not be used). Insulation is essential with wood burning stoves due to the high incidence of condensation problems. In all cases a small ventilation hole (usually 15mm) should be provided at the top of the chimney stack to allow any residual moisture to escape. Always follow the manufacturer’s installation instructions carefully.

MAINTENANCE.Care must be taken when sweeping flexible metal liners as the use of an incorrect brush can damage the inner skin. Only polypropylene brushes of the correct diameter and with a plastic balltop should be used.  As a member of the NationalAssociation of Chimney Sweeps, we are trained in the techniques required.



NACE-BIG SFA-Solid-Fuel-Ass-BIG HETAS-Logo Safecontractor-Badge

Chimney Relining...... Multi-Fuel Applicance Installations...... Smoke Tests...... Cowls Fitted...... Furanflex Chimney Liners...... Eldfast Ceramic Coatings...... Nace Cast Insitu Lining System